Rental Equipment

Our skid mounted hot or cold water pressure washers are assembled within a heavy-duty aluminum frame that allows easy access for maintenance. These quiet operation units feature a max output of 5.0 GPM at 3,000 PSI. Each unit contains dual water filters, timer shutdown, stainless steel housing, and pop off valves.

With this industrial use skid mounted hot water pressure washer, you get a great balance of the cleaning power you are looking for in all your industrial cleaning needs.

 Hydraulic power units for all heavy duty applications, D&D Power Units are designed and manufactured for quality & trouble-free operation under the severest conditions. Featuring a centralized control and gauge panel for ease of start up and systems monitoring, The Rugged One comes complete with fully automatic safety shutdown, including low hydraulic oil, oil temperature, engine oil pressure, and engine temperature. A simple manual control valve unloads the hydraulic system allowing start and shutdown under a no load condition. Also, there is no clutch unit to worry about. The power unit is completely self contained and can provide hydraulic power in the most remote locations. 

Standard Features and Benefits

Due to the versatility of the sludge pump, many users prefer it even though the horse power per gallon is greater than the Trash Pump. The additional power requirements and somewhat reduced volume of the Sludge Pump, is more than offset by the extended life of the unit in certain abrasive pumping requirements. The Sludge Pump is ideal for pumping mud, sewage, silt, and other viscous materials, that cannot be pumped with conventional lift pumps. Sludge pumps are available in 4″ and 6″ diameter discharge.

Submersible Open Type Sludge Pump

The submersible Sludge Pump has all the advantages of the open type trash pump, but due to the impeller design, it will pump extremely high percent solid content liquids. The Sludge Pump impeller is of the tapered vane design. It permits the water to enter the bottom eye of the housing and accelerates the liquid in a radial fashion out the concentric discharge usually in one revolution. With impeller types of this configuration, large solids can be passed without clogging and relatively little impeller wear occurs. Normally, greater horsepower per gallon is required for sludge type pumps.

Special hydraulic motor, provides bearing lubrication.

Flow capabilities: 900 gpm ‐ 2,300 gpm.

Cast steel bearing tube, oil bath bearing lubrication.

304 stainless steel pump shaft, longer pump life.

Two sets of ball bearings, no wear due to side load.

Fabricated iron Volute and impeller.

Special energy transfer impeller, can pump high solid content material with low impeller wear.

Lifting bale, easy to move. 

Inlet screen, keeps out over-sized objects. 

Spin on hydraulic connections, fast setup.

Heavy Duty, Abrasion-Resistant, Solids Handling Pump

• Heavy-Duty, Abrasion Resistant, Solids-Handling Pump
• Heavy duty, high-chrome agitator for sand/ sludge/ slurry applications
• Semi-open chrome impeller and wear plate handles high concentration of abrasive solids
• Double silicon carbide mechanical seals in a separate oil-filled seal chamber
• Class 30 ductile iron
• NPT discharge
• Hardened ductile top discharge motor housing
• Heavy duty ball bearings
• Motor cooled by pumped liquids
• Seal Minder® moisture detection system (optional)
• Hardened ductile iron volute
• Heavy duty lifting rings for easy transport
• Class H motor insulation
• 4 pole motor